INSTALLATION INFORMATION

LOW-RIDER

 The LOW RIDER has a unique feature that allows it to fit several different size transmission humps no matter which type of car you drive. Underneath the “LOW RIDER” are two aluminum coated plates that are curved to accommodate narrow transmission humps on some of the ’60s GM and Ford cars. These aluminum coated plates can be easily adjusted (bent) to conform to just about any automobile transmission hump. If not needed these Aluminum plates can easily be removed.

MODEL-A VAGABOND-L ANDVAGABOND-S CONSOLE

INSTALLATION

Installation is fast and easy WITH NO PERMANENT alterations or tools needed. Simply unscrew the gear shift knob, slip the Shifter Boot over the shifter and slide down to the floor board---- reinstall the shifter knob and your ready to enjoy your new FORD model “A” console with drink holders.

Installation is fast and simple. Just slide the saddle console over the factory console from the back seat forward to desired position.

HUMPHUGGER CRUISER CONSOLE

Rest on Transmission hump between bucket seats and fits over floor shifter( Shifter opening is 4"x6") Brushed alumininum Plate.

SADDLE CRUISER CONSOLE

Full length Console that fits over Factory console. Easy to install  place saddle cruiser console over rear of factory console lower into place and fit shifter through shifter plate opening while lowering the console.

CORVAIR CONSOLE

Slide console from backseat forward between the bucket seats cupholders in front. Adjust to desired position.

BC-CRUISER AND BD-DRINKSTER BENCH SEAT CONSOLES

Install is fast and simple. Place console on bench seat. Using the nylon stap that comes out back of console Run it under bench seat to the front and attach it to the nylon strap with bucklet hat is attached to front of console.